Application
Convert signal outputs (HTL in TTL or TTL in HTL)
OM 3-1
The pulse converters (signal converters) convert rotary encoder signals from HTL to TTL or from TTL to HTL. They are used for electrical isolation, signal level conversion and elimination of interference signals.
The output stages enable signal transmission over long cable lengths at high output frequencies. Optocouplers isolate the inputs from the outputs.
Short circuit or overload of the output stages are signalled. The modules can be attached to standard mounting rails (EN 50 022)..
Take a look at our animations for the steel, crane and port technology, and mining sectors! Click through our animations from a rough overview to the specific mounting location of an encoder and get direct suggestions for suitable encoder solutions.
Convert signal outputs (HTL in TTL or TTL in HTL)
12-30 VDC
HTL (square wave 12-30 V) or TTL (square wave 2.8-6 V)
HTL or TTL (0°, 90°, N and respective inverted signals)
0-250 kHz
Electronic housing for standard mounting rails
50 x 75 x 52 mm
18 pole PHOENIX COMBICON screw terminals 2.5 mm2
-20 °C to +70 °C
IP20 (switchboard installation)
Isolated conversion of HTL in TTL or vice versa with different supply voltages:
We look forward to your challenges.